MADE TO ORDER IN NEW YORK · SUSTAINABLE PRACTICE, TIMELESS DESIGN

Find Your Fit

Measured once, checked properly.

Height and weight alone let us estimate the rest. Add tape measurements and we check them against each other — catching the mistakes that ruin a garment before a single cut is made, and telling you plainly when no standard size is right for you.

You are measuring for Bloom Baseball Cap. We will bring you back to it when you are done, and carry these numbers with it into your bag.

Your measurements stay in this browser. Nothing is sent to us unless you place an order, and we never ask for a photograph. How we handle data.

Find Your Fit

Let us take you through it.

4 short steps — only the measurements Bloom Baseball Cap is actually cut to. Each one shows you exactly where the tape goes, and where it should not, and checks your answer before you move on.

Your measurements stay in this browser. Nothing is sent to us unless you place an order, and we never ask for a photograph. How we handle data.

Bloom Baseball Cap

Measuring for

Bloom Baseball Cap

Back to the piece

Step 1 of 4

Height

Shoes off, heels together, back against a wall.

Height — front view Diagram showing the correct tape position for the height measurement. HEIGHT FROM THE FRONT

Stand as tall as you naturally do — not stretching. Mark the wall at the top of your head and measure to the floor.

If you are measuring alone, a book flat on your head against the wall gives a clean mark.

Step 2 of 4

Weight

Approximate is genuinely fine.

It is used only to work out what your other measurements are likely to be, so that we can check them. It is never shown to anyone and never printed on anything.

Round to the nearest five pounds or two kilos if you prefer.

Step 3 of 4

How you like things to fit

This scales the room each pattern already allows.

Every piece is cut with a certain amount of room in it. This tells us whether to hold you to that, or to lean closer to the body or further from it. It does not change your measurements.

Kept only as a broad band, and only if you order.

If you are unsure, leave it as the piece is cut. That is how the pattern was drafted.

Step 4 of 4

Head

For anything that sits on it.

Head — front view Diagram showing the correct tape position for the head measurement. HEAD FROM THE FRONT

Around the head, just above the ears and across the middle of the forehead — where the band of a hat would actually sit. Snug, not tight.

The mistake to avoid

Too high, above the forehead, reads small and gives a hat that rides up.

Hair down, as you would wear it. A tight bun changes this by half an inch.

Nothing leaves this page until you choose to save it.